Active Job window

The Active Job window reports the progress of your job. The following figure shows the Active Job window after the load is complete.
Figure 1. The Active Job window
begin figure description - This figure is described in the surrounding text. - end figure description

When the Active Job window reports that the load job is complete, click OK to return to the Load Job Select window.

Verify the transfer of data

You can use DB-Acess to verify that the data from /work/mydata was transferred into your database.

Perform a level-0 backup

The onpload utility does not log the data that it writes to a table during an express-mode load. For safety, onpload flags the dbspaces that are associated with the table as read-only. To allow for data recovery in case of disk corruption, you must make a level-0 backup. A level-0 backup on the dbspaces affected by the express-mode load saves the data and unsets the read-only flags.

If you do not care about data recovery, you can make a level-0 backup by using /dev/null as the backup device. This action unsets the read-only flag without backing up data to any real device.

Copyright© 2018 HCL Technologies Limited